Car Parts
Online Catalogue
Main Page
Watch USER'S Ratings
FORUM
 
Audi Cabriolet, year - 1994
Page:   CYLINDER BLOCK WITH PISTONS / OIL SUMP / F >> 8G-W-000 105 / 2.6/2.8ltr. / 6 cylinder
«« Previous illustration  Return to group list   Next illustration »»

For security measures, illustrations and partnumbers are shown only to registered users.

To register, as a new user or merchant  

Partlist:

cylinder block with pistons / 2.6/2.8ltr. / 6 cylinder
oil sump / F >> 8G-W-000 105 / cylinder block with pistons / 2.6/2.8ltr. / AAH,ABC,ACZ
oil sump / F >> 8G-W-000 105
/
cylinder block with pistons / F >> 8G-S-001 302
/ ABC
cylinder block with pistons / F 8G-S-001 303>>
/ ABC
cylinder block with pistons / F >> 8G-S-001 302
/ AAH
cylinder block with pistons
/ ACZ
spring sleeve
13X30,5 /
torx head screw
M11X1,5X90 /
allen key head bolt
M8X45 /
locking cover
36,6 /
locking cover
16 /
spring pin
6,2X22 /
parallel dowel pin
8H8X14 /
non-return valve
/
gasket
/
locking cover
/
washer
A6,4X12,5X1,6 /
hexagonal head bolt
M6X20 /
gasket
/
sealing flange / F >> 8G-P-015 000 / also use:
rear N 010 215 27 N 011 524 23 /
hexagonal head bolt
M6X20 /
gasket / see illustration:
115-40 /
gasket / F >> 8G-S-001 302
/
gasket / F 8G-S-001 303>>
/
oil sump-upper part / F >> 8G-S-001 302
/
oil sump-upper part / F 8G-S-001 303>>
/
round seal
11X3-N /
drain plug
/
locking cover / F >> 8G-S-001 302
/
gear carrier / F 8G-S-001 303>>
/
hexagonal head bolt
M6X20 /
gasket / F >> 8G-S-001 302
lower /
gasket / F 8G-S-001 303>>
lower /
oil sump-lower part / F >> 8G-S-001 302
/
oil sump-lower part / F 8G-S-001 303>> / also use:
N 013 849 2 N 906 606 01 /
hexagonal head bolt
M6X20 /
seal
A26X31 /
seal
A14X20 /
sealing plug
M26X1,5 /
sealing plug
A-M14X1,5X18 /
junction
/
seal
A10X16 /
banto bolt
6 /
set of gaskets for cylinder block / F >> 8G-S-001 302
/

Last forum topics about this model
Jag behöver tips om hur man får bort dörrpanelen på fram dörren på en
audi 80 92 cabrio 2,3.
vänster dörr går inte att låsa.....

b

Posted by humle62 (Sweden) 2008-08-11 20:02:34 AUDI Audi CabrioletNo comments yet ...Open thread »»

Can anyone help?

I recently replaced my ribbed belt and tensioner, due to the old belt shredding on the inner portion. I suspected that this was due to wear in the tensioner hence I replaced that too. Today I noticed that the new belt is going the same way after only 1 month.Disappointing!

I have noticed that there is approx 5 mm of end float on the hyd pump shaft, is this normal or is this the likely cause?

Would appreciate any info to hopefully avoid a hefty garage bill.

Thanks in advance

Posted by chiffs (United Kingdom) 2008-07-20 03:22:57 AUDI Audi CabrioletNo comments yet ...Open thread »»

I need this part No.: 8G0959255A . Please tell me how much does it cost in Russian Federation. How i could buy it. And where to receive it?

Thank you,
Rytis

Posted by bokstas (Lithuania) 2006-05-14 22:57:13 AUDI Audi CabrioletComments: 1, last 2006-05-18 12:16:42Open thread »»