Car Parts
Online Catalogue
Main Page
Watch USER'S Ratings
FORUM
 
Audi 80/90/Avant, year - 1991
Page:   DIFFERENTIAL / PINION GEAR SET / FOR 4-SPEED AUTOMATIC GEARBOX
«« Previous illustration  Return to group list   Next illustration »»

For security measures, illustrations and partnumbers are shown only to registered users.

To register, as a new user or merchant  

Partlist:

differential
pinion gear set / for 4-speed automatic gearbox / differential / AEL
pinion gear set / for 4-speed automatic gearbox
/
differential housing
/
pinion gear set
37/10 /
hexagonal head bolt
M10X1X18 /
1 set: differential pinions
ball:92mm /
housing-differntial pinion
ball:92mm /
shaft - differential pinion
/
taper roller bearing
41X68X17,6 /
output shaft
/
securing ring
/
adjusting washer
0,55 /
adjusting washer
0,6 /
adjusting washer
0,65 /
adjusting washer
0,7 /
adjusting washer
0,75 /
adjusting washer
0,8 /
adjusting washer
0,85 /
adjusting washer
0,9 /
adjusting washer
0,95 /
adjusting washer
1 /
adjusting washer
1,05 /
needle sleeve
/
oil seal
32,3X48X7 /
round seal
32,6X2 /
joint flange
130 right /
securing ring
28X1,5 /
speedometer drive gear
/
cover for final drive
/
hexagonal head bolt
M8X30 /
round seal
188X3 /
oil drain plug, magnetic
M24X1,5 /
distance sensor
/
round seal
14,5X2 /
oil seal
45X65X8/10 /
flange shaft
130 left /
screw
84 /

Last forum topics about this model
I have an old Audi 80 - year model 1987 - still going strong, but I have one problem:

Sometimes - usually after driving more than an hour - it refuses to start again. It doesn't make any sound.

Then after maybe half an hour it starts normally.

It is quite unpleasant because I have no idea, why it does that ( =doesn't start)

I have a new starter, new cables to the starter, new ignition key system...

After replacing practically everything between the ignition key and the starter motor I found a relay, which is called "relief terminal relay".

Somebody told me that it is also so called x-contact relay, which has many purposes.

Could anybody tell me the meaning of this relay?

Could it be the cause for that mysterious starting problem?

It would be nice know if somebody else has had this problem...

Posted by hangab (Finland) 2008-09-04 22:22:35 AUDI Audi 80/90/AvantComments: 2, last 2008-11-17 12:38:46Open thread »»

Hi!
I have problem.
I cannot open my rear door using the handle.
The handle is not tensed anymore and it is soft(you can pull in order to open the trunck but with no result)

I put out the inner door ornament in order to see the mechanism.
Now... my big problem is... how should it be correctly assebled?
I looked on http://www.vagcat.com/epc/cat/au/A80/1994/150/56/1612769/ but i did not understand much.

Can you give me some info about what should i do to repair it?

Thanks!
razvan.c.radulescu@gmail.com

Posted by rcrazvan (Romania) 2008-08-22 20:14:30 AUDI Audi 80/90/AvantNo comments yet ...Open thread »»

Hi to you all. I hope somebody can help me? My Audi is a 1994 model 80 TDi.
The speedometer has stopped registering mileage done. Can someone tell me which sensor I need to replace and where is it situated? This is a fantastic site, I only wish it could add where some of the elusive parts are on the car. I thank you all in advance.
Johnro

Posted by johnro (United Kingdom) 2008-08-21 02:13:38 AUDI Audi 80/90/AvantComments: 2, last 2008-08-23 19:28:11Open thread »»

Where can I find a Non-return valve?
Pierburg Part#: 041.906.291.A

Posted by shogun (United States) 2008-08-05 03:04:56 AUDI Audi 80/90/AvantNo comments yet ...Open thread »»

Hi, I have an Audi 80 -94, with a few problems related to the cooling system:

1. The water in the expansion tank is completely cold even after 30 minutes of driving (not sure when this problem started). The radiator seems to have normal temperature.

2. Also the warning lamp is flashing all the time (this appeared a few days ago).

3. The fan always run when the ignition is on (these has been a fact for a year or so). I believe I should just exchange the thermo-switch?

I have an oil temp meter saying it's about 70C (158F 431K) and when touching the engine it seems to have normal temperature.

So it's probably two different faults (or maybe three). I tried yesterday to exchange the expansion tank, with the water level switch, with no success.

Regards Magnus

Posted by BlombergM (Sweden) 2008-03-08 17:12:16 AUDI Audi 80/90/AvantComments: 3, last 2008-11-25 21:37:57Open thread »»