Car Parts
Online Catalogue
Main Page
Watch USER'S Ratings
FORUM
 
Audi 100/Avant, year - 1994
Page:   BLOWER / HEATER UNIT / heater
«« Previous illustration  Return to group list   Next illustration »»

For security measures, illustrations and partnumbers are shown only to registered users.

To register, as a new user or merchant  

Partlist:

blower / heater
heater unit
/
clips
/
washer
/
housing half
left /
housing half
right /
locking flap
/
seal for flap
/
air duct
/
gasket
1400MM /
gasket
1360MM /
gasket
15MM /
no longer available
/
gasket
15X10X468MM /
gasket
20X10X220MM /
lever for locking flap
lhd /
lever for locking flap
rhd /
control flap
/
flap for warm air cut-off
/
flap for defroster and footwell
/
lever for warm air cut-off flap
/
operating rod
/
connecting rod
/
intake shaft
lhd /
intake shaft / for dust-pollen filter / for service installation / also use:
lhd 4AO 819 439 A 4A1 819 445 A /
flap for fresh and hot air
/
control flap
/
distance piece
/
grommet
/
connecting rod
/
connecting rod
/
angled lever for control flap
/
lever for air distribution
/
lever for control flap
/
stop buffer
/
felt ring
/
mounting clip
/
retainer
/
holder for puller
rhd /
filter housing / for dust-pollen filter
lhd /
filter housing / for dust-pollen filter / for service installation
lhd /
filter element / for dust-pollen filter
lhd /
dust and pollen filterelement / for service installation
310X196MM lhd /
satin black
/
grommet
/
holder for puller
rhd /
tensioning strap
rhd /
tensioning strap
/
tensioning strap
/
blower motor with fan
/
series resistor
/
washer
8,4X15X1,6 /
washer
B3,7X11X0,8 /
lock washer
6 /
securing ring
25X1,2 /
oval head panel screw
ST3,5X13-C /
oval head panel screw
3,5X16 /
oval hd. csk. self-tapp. screw
B4,8X16 /
snap nut
ST3,5X16,75X11 /
snap nut
B4,8X19X16 /
pop-rivet
A3,2X10X8 /
panel screw
BZ4,2X32 /
clamping washer
B-5X11,4 /
panel screw
B4,2X35 /
lock washer
8 /
cable tie
4,5X200 /

Last forum topics about this model
AUdi 100 stalls occasionally and hard starting when engine is hot
My 1991 Audi 100 (about 150K mileage) sometimes stall when slowing down on an incline or sudden braking .Also has starting problems when engine is hot. It's OK if restart immediately after switching off but if I wait 5 minutes or so, it is difficult to start. From observation it appears to be flooding because after a 5 or 6 cranks it slowly comes back to life!! Smells of petrol when I am driving sometimes. No problem starting in the morning. Could it be the coolant temperature sensor?. Is the oil temperature sensor the same item? Really having tough time trying to figure out the fault. Hope someone can help. Thanks

Posted by kktheng (Malaysia) 2008-06-23 13:27:17 AUDI Audi 100/AvantComments: 5, last 2008-11-01 17:23:10Open thread »»

Discrepancy of part No.
Your part No. 034 906 161 & 034 919 369C is different from ETOS. I need to get a temp sensor. Which is correct? Thank you

Posted by kktheng (Malaysia) 2008-06-23 05:47:57 AUDI Audi 100/AvantNo comments yet ...Open thread »»

Needle bearing Porsche 924 2.0 (audi)
Does 047 105 311 exists ?, and I will also need the needlebearing on the crankshaft (for the axel too gearbox)

Posted by Eantmichel (Norway) 2008-05-20 20:39:03 AUDI Audi 100/AvantNo comments yet ...Open thread »»

Hello I need partnummer 431.711.221 for my Audi 100
Hello

where can i find partnummer 431 711 221

Please let me know.

Waar kan ik onderdeel 431 711 221 kopen voor de versnellings bediening
van mijn Audi 100 Ls 1977

Graag in Holland

Wie o wie

Posted by sky (Netherlands) 2007-11-05 23:44:19 AUDI Audi 100/AvantComments: 3, last 2008-03-29 15:17:13Open thread »»